home

 

	download PDF	Motor Technology - 04S
	request details	60V-DC servodrive for brushed servomotors
	view printer friendly page

The 04S series has the same enhanced features as our higher powered controllers.

The built-in power pack is equipped with a ballast circuit with a patented -w- characteristic. Therefore, several 04S units can be supplied from one isolating transformer and can be connected in parallel to the intermediate circuit.

The auxiliary voltages required internally are generated by the controller from the intermediate circuit voltage also when supplying voltage from batteries.

 
A 84TE basis unit can accommodate up to 6 units of the 04S series.

Power supply

The 3-phase supply voltage has to be taken from an isolating transformer. In case of 1-phase supply, nominal voltage and impulse current must be reduced. This requires a specific inquiry.

Basic equipment

• Ballast circuit with -w-characteristic(DC-link can be connected in parallel)

Monitors

• Even without armature circuit chokes, the controller is earth-fault and short-circuit proof.

• In order to obtain a form factor of 1.01, a minimum inductive load of 0.6mH is necessary in the armature circuit.

Dimensions

• Eurocard, 14TE width, 220mm insertion depth

Connections

• Rear panels:

  -F03SMB- connections from rear side (6HE)
  -R03SMB- connections from front side (6HE)

  or

• Mating connector:

  DIN 41 612-M24+7(FH24+7)

CE- conformity

The transistorised controller 04S meets all relevant standards :

• EMC Directive 89/336/EWG

Options

• auxiliary voltage supply from external 24V DC voltage

• armature voltage control (that means speed control without tacho)

• Front panel

Technical data (extract)

Wiring diagram