Search
Close this search box.

The DIS-2 48/10 is a fully digital AC servo controller for three-phase synchronous and PM DC motors with a supply voltage of 24..48 V DC.
The DIS-2 is optimally suitable for the decentralized employment. It can be mounted directly to the terminal block of the motor or used as a stand alone unit.
There are a number of operating modes to choose from: torque, speed or position control.
Programming and diagnosis are possible via an RS232 or CAN bus interface. The parameterisation program “DIS-2 ServoCommander™” can be used to quickly, easily and comfortably parameterise the DIS-2.

Features

  • Compact design with one PCB
  • Direct mounting on the motor
  • 24..48 V DC, 15 A rated current 40 A maximum current
  • High enclosure class up to IP67 when mounted
  • Housing temperature up to +70°C
  • Encoder evaluation: Resolver, digital and analogue hall sensors, SinCos encoder with HIPERFACE (incremental encoder feedback in preparation)
  • Interfaces: RS 232, CAN bus, additional extension slot e.g. PROFIBUS
  • Integrated CAN-Bus interface with DSP402

Technical Data

 DIS-2 48/10
Supply voltage24…48 VDC; +/- 20%
 Rated current IRate 10 Aeff
 Maximum current IMax for 5 sec32 Aeff
 Rated power PRate500 VA on 48 VDC
 Maximum power PMax1500 VA on 48 VDC
 Clock frequency fPWM10 kHz
 Ambient temperature0° to +70 °C
 System of protectionIP54, prepared for IP67
 Dimensions in mm (H x W x D)110 x 80 x 56
 Encoder evaluation Resolver, digital and analogue hall sensors,  incremental encoders, sincos encoder with HIPERFACE
 Interfaces RS 232, CAN bus, additional extension slot e.g. for PROFIBUS